Elgar CW 801P-V Instructions d'exploitation télécharger pdf (Page 32)

Elgar CW-M Series

To utilize remote sensing at the user's load, follow these steps:

1. Remove the protective cover from the terminal block.

2. Route the cables through the strain relief device located above the terminal block.

Twisted shielded leads for power and sense leads are recommended for the lowest

noise operation. If used, shields should be connected to a CW output terminal block

GND ground connector, as shown in Figure 3–9.

3. Disconnect local–sense shorting jumpers. See Figure 3–9.

4. Connect the sense leads as shown in Figure 3–9.

5. Reinstall the protective cover on the terminal block.

Figure 3–9 Sense Connections

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Pas de commentaire

Elgar CW 801P-V Instructions d'exploitation Page 32